User's Manual

605-0000-742_MicroMAX_Hardware_Installation_Rev_H

2. Attach the clamping bracket to the mounting bracket:

a. Slide an M6-spring lock washer onto an M6-hex head screw. Align the mounting

bracket's and clamping bracket's pivot holes, such that the clamping bracket is aligned

to the inside of the mounting bracket. From the external side of the mounting bracket,

insert the M6-hex head screw into the pivot holes and then fasten, but not tightly. (The

clamping bracket provides a built-in nut.)

b. Choose an elevation hole on the mounting bracket and then align it with the

corresponding hole on the clamping bracket. Slide an M6-spring lock washer onto an

M6-hex head screw, and then from the external side of the mounting bracket, insert

the M6-hex head screw through the elevation hole on the mounting bracket and into

the clamping bracket's corresponding hole. Fasten but not tightly the M6-hex head

screw (the clamping bracket provides built-in nut). The elevation hole can later be

changed according to desired antenna orientation in the elevation plane.