User's Manual

605-0000-742_MicroMAX_Hardware_Installation_Rev_H
58
Note:
Ensure that:
The POSITIVE output of the AC/DC Converter is connected to the POSITIVE (Red) input
(lower) on the BSDU.
The NEGATIVE output of the AC/DC Converter is connected to the NEGATIVE (Black) input
(upper) on the BSDU.
Cable Connection
Caution: Confirm that all inputs to the AC/DC converter are either disconnected or
powered off prior to installing the cable, otherwise damage may occur to either or both
devices.
To connect the BSDU to AC/DC Converter Cable
1. Connect the end of cable 63000110 labeled BSDU to the PS MNG port on the back panel of
the BSDU, as shown below.
2. Connect the end of cable 63000110 marked ‘PSU’ to the ‘J1’ port on the back panel of the
AC/DC Converter, as shown below.
3. Connect the Black crimped wire from the 25-pin cable connected to Port J1 on the back
panel of the AC/DC Converter to the –VDC (Negative) output of the AC/DC Converter on
the back panel, as shown below.