User's Manual

605-0000-742_MicroMAX_Hardware_Installation_Rev_H
50
Connecting BSDU to PC for SNMP Management
To configure the BSDU, or BSRs connected to the BSDU, through an IP network communication
mode, you can connect the BSDU directly to the PC, or remotely (from anywhere) if you have
IP connectivity to the PC.
For PC-to-BSDU local network connections you need to connect the PC to the BSDU's
management port.
The following lists the cable setup for BSDU local network management:
Cables:
o Straight-through for connecting the PC to the BSDU management port
Connector: 8-pin RJ-45
Connector pinouts:
Straight-through cable
PC LAN port BSDU
management
port
8-pin RJ 45 8-pin RJ 45
Pin Signal Pin Signal
1 Tx+ 1 Rx+
2 Tx- 2 Rx-
3 Rx+ 3 Tx+
6 Rx- 6 Tx-
To connect the BSDU to PC for IP network management
1. Connect the RJ-45 connector, at one end of the straight-through cable, to the BSDU's
management port.
2. Connect the RJ-45 connector, at the other end of the straight-through cable, to the PC's
LAN port.
BSDU-to-PC local network management cabling