User's Manual
Table Of Contents
- INTRODUCTION
- WARNINGS AND CAUTIONS
- DECLARATION OF CONFORMITY
- FCC NOTICE
- SYSTEM OVERVIEW
- INSTALLATION PREREQUISITES
- PHYSICAL DESCRIPTION
- BSDU DESCRIPTION
- GPS DESCRIPTION
- AC/DC POWER CONVERTER
- MOUNTING THE BASE STATION RADIO (BSR)
- MOUNTING THE BSDU
- MOUNTING THE GPS
- MOUNTING AC/DC POWER CONVERTER
- CABLING THE BSR
- CONNECTING THE SDA-4S TO THE POWER SUPPLY
- CONNECTING POWER CABLE FOR SDA-4SDC
- CONNECTING BSDU TO AC/DC POWER CONVERTER
- CONNECTING LIGHTNING AND SURGE PROTECTOR
- CONNECTING THIRD-PARTY EXTERNAL ANTENNAS
- TRADEMARKS AND COPYRIGHTS
- ENVIRONMENTAL
- CONTACT INFORMATION
- REVISIONS
- WARNINGS
- GLOSSARY
Mounting the Base Station Radio (BSR)
29
To pole mount the MicroMAX BSR:
1. Attach the mounting bracket to the MicroMAX:
a. Align the mounting bracket with the MicroMAX's mounting holes so that the mounting
bracket's side with the built-in nut is aligned with the BSR's mounting holes furthest
from the MicroMAX's bottom panel, as shown in the figure below.
b. Slide an M10-flat washer and M10-spring lock washer onto an M10-hex head screw
(ensure spring lock washer is closest to the bolt's head). From the external side, insert
the M10-hex head screw through the mounting bracket and MicroMAX's mounting
holes. Fasten the M10-hex head screw (one is provided with a built-in nut while the
other requires you to insert an M10-hex nut into the MicroMAX's mounting hole).