User's Manual

ManualsBrandsAirspan Networks ManualsElectronicsBase station radio MicroMAX 3.7 GHz TDD

Table Of Contents

INTRODUCTION
- Purpose
- Targeted Audience
- Referenced Documentation
- Conventions
WARNINGS AND CAUTIONS
- Human Exposure to Radio Frequencies
- Radio Interference
- Avoiding Radio Interference
- Modifications
- General
- Manufacturer's Disclaimer Statement
DECLARATION OF CONFORMITY
- European Community, Switzerland, Norway, Iceland, and Liecht
- Declaration of Conformity with Regard to the R&TTE Directive
FCC NOTICE
- Federal Communication Commission Notice
- GPS Compliance
- Maximum Output TX Power
SYSTEM OVERVIEW
- MicroMAX Frequency Ranges
- System Components
- Customer Benefits
- Architecture
- Power
- Models
INSTALLATION PREREQUISITES
- Package Contents
- Required Tools
- Radio Site Planning
  - Radio Antenna Alignment
PHYSICAL DESCRIPTION
- MicroMAX BSR
  - Physical Dimensions
  - Ports
- SDA-4S Type II
- SDA-4SDC Type II
BSDU DESCRIPTION
- Physical Dimensions
  - Ports
  - Rear Panel
GPS DESCRIPTION
- Physical Dimensions
  - Ports
AC/DC POWER CONVERTER
- Physical Dimensions
- Redundant PS Unit
MOUNTING THE BASE STATION RADIO (BSR)
- Mounting the MicroMAX
- Pole-Mounting the BSR
- Wall-Mounting the BSR (Optional)
- Installing the SDA-4S
  - Wall Mounting
MOUNTING THE BSDU
- Mounting the BSDU
  - Desktop mounting
  - Rack mounting
MOUNTING THE GPS
- Mounting the GPS
MOUNTING AC/DC POWER CONVERTER
- Mounting the AC/DC Power Converter
  - Rack mounting
- Connecting Redundant PS Unit
CABLING THE BSR
- Connecting the BSR to the SDA-4S
- SDA-4S Type II
  - Using the SDA-4S Type II
- Connecting the BSR
CONNECTING THE SDA-4S TO THE POWER SUPPLY
- Connecting the SDA-4S Type II
- Connecting the SDA-4SDC Type II
- Connecting SDA-4S to Ethernet Network
CONNECTING POWER CABLE FOR SDA-4SDC
- Power Cable Connection
  - Housing the Connectors
  - Connecting to the SDA-4SDC
CONNECTING BSDU TO AC/DC POWER CONVERTER
- Connecting BSDU to AC/DC Power Converter
- Cable Connection
CONNECTING LIGHTNING AND SURGE PROTECTOR
- PolyPhaser Wiring Diagrams
  - Lightning and Surge Protection Connection Scenarios
CONNECTING THIRD-PARTY EXTERNAL ANTENNAS
- Connecting Third Party External Antennas
- Connecting GPS Antenna to BSDU
  - Connecting the GPS
  - GPS Alignment
TRADEMARKS AND COPYRIGHTS
ENVIRONMENTAL
- Environmental Conditions
  - BSR and SDA
  - BSDU
CONTACT INFORMATION
REVISIONS
WARNINGS
- 1. Disclaimer
- 1.1 Safety Warnings
- 1.2 Important Warning Symbols
- 1.3 Important Service Information
- 1.4 UL Information
- 1.5 CE Notice
- 1.6 European Community, Switzerland, Norway, Iceland, and L
  - Declaration of Conformity with Regard to the R&TTE Directive
- 1.7 CAUTION
- 1.8 Lightning Protection
GLOSSARY

605-0000-742_MicroMAX_Hardware_Installation_Rev_H

SDA-4SDC Type II

The SDA-4SDC Type II indoor unit is an integrated LAN switch, providing power and four

10/100BaseT ports for interfacing with the subscriber’s network and especially designed for

implementation where available power supply is DC. This model provides regulated –48 VDC

power. The unit is displayed in the figure below.

This subsection provides the following SDA-4SDC physical descriptions:

Dimensions

Ports

LEDs

Physical Dimensions

The SDA-4SDC physical dimensions are described in the table below:

Parameter Value

Dimensions Height - 200mm (7.87 inches)

Width - 150mm (5.9 inches)

Depth - 40mm (1.57 inches)

Weight 0.53 Kg