User's Manual
Table Of Contents
- 1 About this Guide
- 2 Introduction
- 3 Getting Started
- 4 Verify Prerequisites
- 5 Install MacroMAXe
- 6 Connect and Manage Cables
- 7 Set Power System
- 8 Appendix A
- 9 Appendix C – Glossary of Terms
- 10 Appendix D – Installation Checklist
- 11 Appendix E
MacroMAXe Installation Guide
Page 41 Commercial in Confidence UGD-D00181 Rev E
Figure21‐GPScableassemblypriortomounting
3. Hand-tighten the RG58 cable TNC (90°) connector to the mating connector on the GPS
antenna.
Figure22‐AttachGPSantennatoRG58cable
4. Slide the flat washer up to the underside of the mounting bracket, then thread 1 nut onto the
GPS antenna threaded base and tightened.
5. The second nut is then secured and tightened against the first nut to create a clamp load
against the first nut, as shown below:
Figure23‐GPSantennaassembledonbracket