User's Manual
Table Of Contents
- 1 About this Guide
- 2 Introduction
- 3 Getting Started
- 4 Verify Prerequisites
- 5 Install MacroMAXe
- 6 Connect and Manage Cables
- 7 Set Power System
- 8 Appendix A
- 9 Appendix C – Glossary of Terms
- 10 Appendix D – Installation Checklist
- 11 Appendix E
MacroMAXe Installation Guide
Page 40 Commercial in Confidence UGD-D00181 Rev E
Figure19‐Variabletiltantenna
Figure20‐AntennamountedonMacroMAXe
5.5 GPS Antenna Assembly
To mount the GPS antenna directly on the MacroMAXe:
1. Route the RG58 cable through the flat washer and the 2 nuts (supplied).
2. Position the RG58 cable below the mounting hole on the GPS antenna mounting bracket, as
shown below: