User's Manual
Table Of Contents
- 1 About this Guide
- 2 Introduction
- 3 Getting Started
- 4 Verify Prerequisites
- 5 Install MacroMAXe
- 6 Connect and Manage Cables
- 7 Set Power System
- 8 Appendix A
- 9 Appendix C – Glossary of Terms
- 10 Appendix D – Installation Checklist
- 11 Appendix E
MacroMAXe Installation Guide
Page 36 Commercial in Confidence UGD-D00181 Rev E
5.3.1 Install Dual Slant Antenna
Figure15‐MacroMAXeAntennaDualSlantMastMountConfiguration
To mount the dual slant antenna for the MacroMAXe in the mast mount configuration, perform
the following steps:
1. Attach the Antenna brackets to the top and bottom of the radome.
2. Attach the tilt arm to the top bracket of the radome.
3. Fasten the ends of the adjustable pipe mounts to the top and bottom brackets of the radome.
4. Lift the radome and place the screws through the adjustable pipe mounts and position the
radome so that the top mounting holes retain the unit.
5. Screw the bottom two screws and washers into the two standoff fittings at the bottom of the
radome assembly.
6. Tighten all fixing screws.
7. Attach, connect and secure antenna RF cable between the antenna and the appropriate
MacroMAXe Antenna RF connection on the top of the unit.