User's Manual
Table Of Contents
- 1 About this Guide
- 2 Introduction
- 3 Getting Started
- 4 Verify Prerequisites
- 5 Install MacroMAXe
- 6 Connect and Manage Cables
- 7 Set Power System
- 8 Appendix A
- 9 Appendix C – Glossary of Terms
- 10 Appendix D – Installation Checklist
- 11 Appendix E
MacroMAXe Installation Guide
Page 35 Commercial in Confidence UGD-D00181 Rev E
1. Attach the Wall Plate to the wall at the height required to attach the MacroMAXe.
2. Fasten the Hangars to the rear side of the MacroMAXe enclosure, position the niched Hangar
so it is lower on the wall with the niche facing down.
3. Lift the enclosure and place the screws through the head clearance holes and position the
unit so that the top mounting holes retain the unit.
Caution: This unit weighs 17 kg, take care when lifting.
4. Screw the bottom two screws and washers into the two standoff fittings at the bottom of the
MacroMAXe enclosure.
5. Tighten all fixing screws.
5.3 Install MacroMAXe Antennas
Use this procedure to install a linear dual slant antenna for the MacroMAXe in the mast mount
configuration.
Figure14–MacroMAXeExternalAntennaConfiguration
Note: Separate Antenna distance according to RF planning.