User's Manual
Table Of Contents
- 1 About this Guide
- 2 Introduction
- 3 Getting Started
- 4 Verify Prerequisites
- 5 Install MacroMAXe
- 6 Connect and Manage Cables
- 7 Set Power System
- 8 Appendix A
- 9 Appendix C – Glossary of Terms
- 10 Appendix D – Installation Checklist
- 11 Appendix E
MacroMAXe Installation Guide
Page 30 Commercial in Confidence UGD-D00181 Rev E
Figure6–MacroMAXeBaseStationUnit,RFports
RF Ports for antenna connections are N-Type Female connectors located on the top of the
MacroMAXe enclosure. Adjacent to these are SMA connectors used for RF monitoring purposes
during installation / maintenance. For normal operation, these are covered with a weatherproof cap.
A 80cm or 16 m RG58 cable connects a remote mounted GPS Antenna to the MacroMAXe by way of
TNC connectors. The cable assembly for the remote GPS antenna is shown below.
Figure7–MacroMAXeCableAssemblyforGPSAntenna
Figure8‐Lightning/Surgeprotector