User's Manual
Table Of Contents
- 1 About this Guide
- 2 Introduction
- 3 Getting Started
- 4 Verify Prerequisites
- 5 Install MacroMAXe
- 6 Connect and Manage Cables
- 7 Set Power System
- 8 Appendix A
- 9 Appendix C – Glossary of Terms
- 10 Appendix D – Installation Checklist
- 11 Appendix E
MacroMAXe Installation Guide
Page 26 Commercial in Confidence UGD-D00181 Rev E
MacroMAXe Base Station parts Consisting of
1 x MacroMAXe installation mount kit
(ordered separately)
8 x male-male threaded studs M8
24 x M8 plain washers
16 x M8 spring washers
8 x M8 nuts
1 x earth kit 1 x M6 screws
1 x M6 washers
1 x M6 spring washers
1 x M6 nut
1 x GPS antenna kit
(ordered separately)
1x GPS Antenna. An active GPS antenna which, by using the
appropriate mounting bracket, can be used with MacroMAXe
for network synchronization.
For mounting directly to the top of MacroMAXe, this GPS
Antenna should be used in conjunction with MacroMAXe GPS
Antenna Top Mounting Kit.
When mounting remotely from the base station units, this
antenna should be used in conjunction with the Remote GPS
Antenna Mounting Bracket & 5m or 16m GPS Cable RG58
TNC-TNC.
30cm or 16m Cable Assembly. 30cm or 16m RG58 cable.
Connects remote mounted GPS Antenna (GPS-ANT-1) to the
MacroMAXe via TNC connectors.
Table4–MacroMAXeinstallationpartsandkits
Parts Images
1 Wall Plate
2 Top Hanger
3 Lower Hanger