User's Manual
Table Of Contents
- 1 About this Guide
- 2 Introduction
- 3 Getting Started
- 4 Verify Prerequisites
- 5 Install MacroMAXe
- 6 Connect and Manage Cables
- 7 Set Power System
- 8 Appendix A
- 9 Appendix C – Glossary of Terms
- 10 Appendix D – Installation Checklist
- 11 Appendix E
MacroMAXe Installation Guide
Page 25 Commercial in Confidence UGD-D00181 Rev E
4.2 Verify Installation Requirements
4.2.1 Verify the Tools
Tool
Large Crosshead Screw driver Phillips # 3 or Pozidrive # 3
Small flat blade screwdriver
Medium flat blade screwdriver
13mm or 1/2 inch open ended spanner
10mm or 13/32 inch open ended spanner
Wire strippers
Wire cutters
Ring terminals crimp tool
RJ45 crimp tool
Table3–MacroMAXeinstallationtools
4.2.2 Verify the Parts and Kits
MacroMAXe Base Station parts Consisting of
1 x MacroMAXe unit Base station unit
3 x RJ45 Weatherproof Connector
Covers
Weatherproof connector covers for use with standard cat 5
RJ45 network connections.
1 x mains cable 14AWG x2 (ordered
separately)
30 meter lead with M17 3 pole plug
When distance from outdoor Power supply to Base Station is over 30 meters additional power cable
must be connected via a junction box (ordered separately) for total distance of up to 130 meters.
14AWG x2 (ordered separately) – up to 40 meters
12AWG x6 (ordered separately) – up to 100 meters
1 x Ethernet RJ45 environmental
shroud
LTW IP68 or Amphenol environmental connector
1 x Sunshield fixing kit (optional)
(ordered separately)
4 x M6 screws
4 x M6 plain washers
4 x M6 spring washers