User Manual

Air4G-W24 Installation Guide
Page 56 Commercial in Confidence UGD-D00181 Rev G
Figure 43 – Secure fiber-optic cable, use excess tie
Figure 44 – Secure fiber-optic cable, re-use excess tie
8.3 Connecting the Fiber-optic Cable
To secure fiber-optic cable to the Air4G-W24, perform the following steps:
1. Remove the dust cover from end of a panel connector:
Figure 45 - fiber-optic connector with dust cover
Figure 46 – dust cover removed
7. Remove the protective cover from the fiber-optical cable.
8. Align the fiber-optical cable connector and line up the groove on the cable connector with
the pin on the panel connector.
9. Screw the connecter cover nut until hand-tight.