User Manual

Air4G-W24 Installation Guide
Page 51 Commercial in Confidence UGD-D00181 Rev G
10. Open the connector clamp collar and feed about 101.6 mm (4 inches) of cable from the
Air4G-W24 through it and into the box. Tighten the collar around the cable, forcing the
seal to compress around the cable.
11. Replace the cover by using the four (4) screws, ensuring the gasket (for weatherproofing)
is firmly in place on the rim of the cover.
Note: It is important to provide strain relief and drip loop for the cables. Create a
drip loop and strain relief using cable tie, to tie cable to pole, as displayed in the
figure below:
Figure 35 - Air4G-W24 assembly with optional junction box