User Manual

Air4G-W24 Installation Guide
Page 15 Commercial in Confidence UGD-D00181 Rev G
Dual slant cross polarized (X-Pol) antenna with two (2) ports - connected via 2 RF
jumper cables to Air4G-W24.
Omni antennas – for 360 degree coverage using a single Air4G-W24 - requires
an Omni antenna for each receiver – 2 or 4 Omni antennas.
Note: The Omni antennas must be separated – with at least one meter
separation from each other (in 2.X and in 3.X GHz)
Fixed tilt dual/quad port antennas (where the tilt is set by the way the mounting kit
is installed).
Note: Required mounting kits for fixed tilt dual/quad port antennas are
included.
Manual Electric Tilt (MET) dual/quad antennas - a variable tilt antenna available
for mounting directly on the Air4G-W24 with no need for physical tilting of the
antenna.
The following table describes different antenna arrays when using either two (2) receivers or four
(4) receivers:
Table 7 - Antenna arrays
Frequency Band
# of Receivers
Sector
Antenna Type
# of Antennas
700 MHz
2
60º
698 - 806 MHz 60º 13.5 dBi
Dual X-Polar
1
700 MHz
4
60º
698 - 806 MHz 60º 13.5 dBi
Dual X-Polar
2
2.3 GHz
2
65º
2.3-2.7 GHz 60º Dual Slant X-
Polar
1
2.3 GHz
4
65º
2.3-2.7 GHz 60º Quad X-Polar
1
2.5 GHz
2
65º
2.3-2.7 GHz 60º Dual Slant X-
Polar Antenna
1
2.5 GHz
4
65º
2.3-2.7 GHz 60º Quad X-Polar
1
3.3-3.8 GHz
2
65º
3.3-3.8 GHz 60º Dual Slant X-
Polar
1
3.3-3.8 GHz
4
65º
3.3-3.8 GHz 60° Quad X-Polar
1
700 MHz
2
90º
698 - 806 MHz 90° 12.5 dBi
Dual X-Polar
1
700 MHz
4
90º
698 - 806 MHz 90° 12.5 dBi
Dual X-Polar
2
2.3 GHz
2
90º
2.3-2.7 GHz 90° Dual Slant X-
Polar
1
2.3 GHz
4
90º
2.3-2.7 GHz 90° Quad X-Polar
1
2.5 GHz
2
90º
2.3-2.7 GHz 90° Dual Slant X-
Polar
1
2.5 GHz
4
90º
2.3-2.7 GHz 90° Quad X-Polar
1
3.3-3.8 GHz
2
90º
3.3-3.8 GHz 90° Dual Slant X-
Polar
1