User Manual

Air4G Installation Guide
Page 52 Commercial in Confidence UGD-D00181 Rev G
Figure 37 – Secure fiber-optic cable, use excess tie
Figure 38 – Secure fiber-optic cable, re-use excess tie
8.3 Connecting the Fiber-optic Cable
To secure fiber-optic cable to the Air4G, perform the following steps:
1. Remove the dust cover from end of a panel connector:
Figure 39 - fiber-optic connector with dust cover
Figure 40 – dust cover removed
7. Remove the protective cover from the fiber-optical cable.
8. Align the fiber-optical cable connector and line up the groove on the cable connector with the
pin on the panel connector.
9. Screw the connecter cover nut until hand-tight.