User Manual

Air4G Installation Guide
Page 27 Commercial in Confidence UGD-D00181 Rev G
Air4G Base Station parts
Consisting of
Note: The Sunshield brackets are only applicable for antennas that utilize
Mechanical Electric Tilt (MET). i.e. – Argus-SSPX310F.
Warning: A Sunshield is mandatory for temperatures of above 45°.
1 x Air4G installation
mount kit
(ordered separately)
M8 x 20 Hex Cap screws – 8
M8 Hex nuts - 4
M8 plain washers – 8
M8 spring washers - 8
Pole Mount Bracket
Assembly:
Dia. 120-230 mm – top &
bottom – plus fixing
accessories.
(ordered separately)
Accessories included
Pole Mount Bracket
Assembly:
Dia. 60-120 mm – top &
bottom – plus fixing
accessories.
(ordered separately)
Accessories included
1 x earth kit
1 x M5 screws
1 x M5 washers
1 x M5 spring washers
Alternative: SEMS screw (includes 2 washers)
GPS antenna &
accessories
(each ordered separately)
1x GPS Antenna. An active GPS antenna which, by using the
appropriate mounting bracket, can be used with Air4G for network
synchronization.
For mounting directly to the top of Air4G, this GPS Antenna should be
used in conjunction with Air4G GPS Antenna mounting bracket
w/Handle pre-assembled on the Air4G and the 5m GPS Cable RG58
TNC-TNC.
When mounting remotely from the base station unit, this antenna should
be used in conjunction with the Remote GPS Antenna Mounting Bracket
(GPS-MNT-1) and the 16m GPS Cable RG58 TNC-TNC.
80cm or 16m Cable Assembly - 80cm (CBL-GPS-TNC-0.8-1) or 16m
(CBL-GPS-TNC-16-1) RG58 cable. 16m connects remote mounted
GPS Antenna (GPS-ANT-1) to the Air4G via TNC connectors. The
80cm, cable for mounting GPS directly to the top of Air4G.
GPS Lightning/Surge
protector (ordered
separately)
1x Lightning/Surge protector
AC/DC Power Supply (PS)
Indoor power converter for 700 MHz
Indoor power converter for 2.xGHz