User Manual

Air4G-W24 Installation Guide
Page 57 Commercial in Confidence UGD-D00181 Rev G
Notes:
 There are 4 connections on the Air4G-W24 – optical, Eth1, Eth2 and Eth3.
 The Optical/Eth1 connection is always enabled, and cannot be disabled via
the GUI, to prevent comm-loss. When both are connected, the optical takes
precedence over the Eth1.
6. Enter the BS ID
Note: The format of the BS ID is important: NN-NN-NN-nn-nn-nn (where NN-
NN-NN is the Operator ID and nn-nn-nn is a unique address ID).
7. Select the BS Action from the available list.
8. Leave NTP Server as is (blank).
9. Check Enable Eth2 – to enable the Eth2 port – disable to prevent unauthorized access to
port. Default = enabled
10. Check Enable Eth3 – to enable the Eth3 port – disable to prevent unauthorized access to
port. Default = enabled
11. Click Submit. (Read Current = ignore/no action) (Clear IIB = ignore/no action)
8.1.2 SNMP Agent/Trap Configuration
1. Click SNMP Config, as displayed below:
Figure 43 - SNMP Initial Configuration
2. Define Read Only Community - SNMP read only community name defined by the BS
network provider
3. Define Read Write Community - SNMP read/write community name defined by the BS
network provider.
4. Leave Transport Type as is.
5. Leave BS Mgmt SNMP IP as is.
6. Leave the BS Mgmt SNMP Port number as is. Default = 161
7. Define the SNMP Trap Dest IP Addr. (IP address of Netspan)