User Manual

Air4G-W24 Installation Guide
Page 48 Commercial in Confidence UGD-D00181 Rev G
Figure 29 - Variable tilt antenna
Figure 30 - Antenna mounted on Air4G-W24
5.6 Antenna Connection
Caution: Antennas 1 & 2 Tx/Rx must be connected and attached before Air4G-
W24 is powered on.
Caution: Attach the appropriate cable to the antenna and hand-tighten. Torque
the N-Type connector to 6.2 - 9.7 in-lbs or 0.7 - 1.1 N-m using either a 19mm or
13/16” open end Torque wrench (depending on coupling type).
Caution: Power down Air4G-W24 prior to disconnecting antenna.
The following describes the antenna connection: