User Manual

Air4G-W24 Installation Guide
Page 44 Commercial in Confidence UGD-D00181 Rev G
5.4.1 Install Dual Slant Antenna
Figure 24 - Air4G-W24 Antenna Dual Slant Mast Mount Configuration
Note: Mounting kit (50 > 115 mm) is included.
To mount the dual slant antenna for the Air4G-W24 in the mast mount configuration,
perform the following steps:
1. Attach the Antenna brackets to the top and bottom of the radome.
2. Attach the tilt arm to the top bracket of the radome.
3. Fasten the ends of the adjustable pipe mounts to the top and bottom brackets of the
radome.
4. Lift the radome and place the screws through the adjustable pipe mounts and position the
radome so that the top mounting holes retain the unit.
5. Screw the bottom two screws and washers into the two standoff fittings at the bottom of
the radome assembly.
6. Tighten all fixing screws.
7. Attach, connect and secure antenna RF cable between the antenna and the appropriate
Air4G-W24 Antenna RF connection on the top of the unit.