User Manual
Table Of Contents
- 1 About this Guide
- 2 System Overview
- 3 Installation Prerequisites
- 4 Physical Description
- 5 BSDU Description
- 6 GPSD Description
- 7 GPS Description
- 8 AC/DC Power Converter
- 9 Mounting the Base Station Radio (BSR)
- 10 Mounting the BSDU
- 11 Mounting the GPS
- 12 Mounting the AC/DC Power Converter
- 13 Cabling the BSR
- 14 Connecting the SDA-4S to the power supply
- 15 Connecting Power Cable for SDA-4SDC
- 16 Connecting BSDU to AC/DC Power converter
- 17 Lightning and Surge Protection
- 18 Connecting Third-Party External Antennas
- 19 Appendix
MicroMAX Hardware Installation User Guide
Page 92 Commercial in Confidence UWB-D00068 Rev J
Figure86‐BSDU+Polyphaser+BSR
The following table describes the connections:
Table32‐Description
Item
#
Description Manufacturer Manufacture
P/N
QuantityComment
1 Copper wire 0 AWG N/A N/A N/A Ground resistance must be
less than 5 Ohm.
Cable should have UL
approval.
2 SFTP Cat-5E
Shielded
N/A N/A N/A up to 100 meters in length
3 Ring terminal N/A N/A N/A Stud H (1/4), Diameter to
match the copper wire
diameter used
4 Circuit Lightning
protection for BSR
Polyphaser IX
series
IX-
2H1L1DC48-
IG
1
InstalledwithBSR