User Manual

Table Of Contents
MicroMAX Hardware Installation User Guide
Page 51 Commercial in Confidence UWB-D00068 Rev J
Figure32‐strainrelief
9.2 Wall-Mounting the BSR (Optional)
Note: The standard BSR kit provides pole-mounting brackets. If you want to
wall-mount the MicroMAX BSR contact your Airspan distributor for pricing
and ordering of wall-mounting brackets.
Note: A minimum of 3 meter separation is required between MicroMAX and
existing customer radio equipment.
Note: A minimum of 1 meter separation should be maintained between
synchronized MicroMAXs (see figure below).
The figure below illustrates the minimum separation between synchronized MicroMAX's :
Figure33‐mountseparation
MicroMAX wall mounting consists of two main stages:
¾ Attaching the mounting bracket to the MicroMAX's mounting holes
¾ Attaching the mounting bracket (already attached to the MicroMAX) to the wall (or pole)
To wall mount the MicroMAX:
1. Position the unassembled mounting bracket on the mounting surface (e.g. wall), and then
use a pencil to mark the position of the four mounting holes. Ensure that the distance
between the hole centers are 120 mm (height) and 60 mm (width), as displayed in the figure
below showing the MicroMAX's fixing dimensions.