User's Manual

Air4G-W24 Installation Guide
Page 64 Commercial in Confidence UGD-D00181 Rev G
9 Appendix A
9.1 Review Job Sheet
The Job Sheet should include the following information:
 BS location and identity.
 Whether the system is required to be locked to a GPS timing reference.
 A BSID is required for each BS TRx. This should be in a format xxxxxx:xxxxxx
where x is a decimal digit.
 Network configuration information for the BS TRx.
 Traffic Port: Not applicable.
 IP Address: Should only be set if Management IP Mode is set to Static IP Address. See
below for Management IP Mode parameter.
 Netmask: Should only be set if Management IP Mode is set to Static IP Address. See
below for Management IP Mode parameter.
 Default Gateway: Should only be set if Management IP Mode is set to Static IP Address.
See below for Management IP Mode parameter.
 Management VLAN: Specified as either Untagged or Tagged
 Management VLAN Tag: Should only be set if Management VLAN is set to Tagged
 Management IP Mode: Specified as Static IP Address or Obtain IP Address via DHCP
 Ethernet Mode: Specified as Auto-negotiate or Fixed
 Ethernet Rate: Need only be configured if Ethernet Mode is set to Fixed, specified as
10M or 100M.
 Ethernet Duplex: Need only be configured if Ethernet Mode is set to Fixed, specified as
Full or Half.
 SNMP configuration information. This will allow events from the BS to arrive at the
specified Netspan server. This will include the following information:
 Read Only Community: This should be specified to the same value as in Netspan
Discovery Parameters (found under Server on Netspan left hand panel).
 Read Write Community: This should be specified to the same value as in Netspan
Discovery Parameters (found under "Server" on Netspan left hand panel).
 SNMP Port Number: This should be specified to the same value as in Netspan
Discovery Parameters (found under "Server" on Netspan left hand panel).
 IP Address: This specifies Netspan IP address (found under Server Global
Configuration, which is under Server on Netspan left hand panel).
 Community: Normally specified to the same value as for Read Only Community.
 Port Number: Normally specified to a value of 9023.
 NTP configuration. This specifies a list of NTP servers.
9.2 Securing Fiber-optic Cable
The Milli-Tie can be used to secure cables in the same manner as normally used for nylon straps.
The steps below show the basic use of the product.
Caution: Over-tightening of cable ties may causes damage and degrade system
performance.
To secure fiber-optic cables, perform the following steps:
1. Place the Millie-Tie around the target, and thread the tongue through the last large
aperture in the rearmost cell.