User's Manual

Air4G-W24 Installation Guide
Page 54 Commercial in Confidence UGD-D00181 Rev G
Figure 37 - Attach GPS antenna to RG58 cable
4. Slide the flat washer up to the underside of the mounting bracket, then thread 1 nut onto
the GPS antenna threaded base and tightened.
5. The second nut is then secured and tightened against the first nut to create a clamp load
against the first nut, as shown below:
Figure 38 - GPS antenna assembled on bracket
6. Connect the RG58 cable attached to the GPS Lightning/Surge protector (required) to the
GPS connection on the bottom Air4G-W24.
7. Verify that the weatherproof cable is in the proper position and hand tighten the cable
(using no tools), to prevent water leakage. Apply self amalgamating insulating tape on all
critical connections.
5.9 LED Display
When powering up refer to the following for indication of BS current status:
Table 20 - LED Display
LED
Name
Color
Status
Description
PWR
Power
Green
On
Power on
Off
Power off
ALM
Alarm
Red
On
Alarm detected
NML
Network
Link
Green
Steady on
Network link detected
Blinking
Traffic currently flowing
STA
In
service
Green
On
Software running