User's Manual

Air4G-W24 Installation Guide
Page 51 Commercial in Confidence UGD-D00181 Rev G
5.6 Cavity Filter Installation
The following demonstrates the correct installation of a Cavity filter for the Air4G-W24 in either the
wall or mast mount configuration.
Note: The Cavity filters are required for the 2.3 GHz variant only.
Figure 33 - Cavity filter(s) installation
5.7 Antenna Connection
Caution: Antennas 1 & 2 Tx/Rx must be connected and attached before Air4G-
W24 is powered on.
Caution: Attach the appropriate cable to the antenna and hand-tighten. Torque
the N-Type connector to 6.2 - 9.7 in-lbs or 0.7 - 1.1 N-m using either a 19mm or
13/16” open end Torque wrench (depending on coupling type).
Caution: Power down Air4G-W24 prior to disconnecting antenna.