User Manual

Air4G-W24 Installation Guide
Page 59 Commercial in Confidence UGD-D00181 Rev G
8. Set the SNMP Trap Port Number (for communications with Netspan) to 162.
9. Click Submit. (Read Current = ignore/no action) (Clear IIB = ignore/no action)
8.1.3 Mgmt IP Config
1. Click Mgmt IP Config, as displayed below:
Figure 45 - Management IP Configuration
2. Define the IP address.
3. Define the Subnet Mask.
4. Define the Default GW MAC Address.
Caution: Define Default GW only if required for Network Security. Consult with
Provider.
5. Set the Management VLAN set to Untagged. Set to Tagged when with VLAN Tag ID.
Consult with Provider.
6. Define the VLAN Tag ID – only when Management VLAN is set to Tagged. Consult with
Provider.
7. Click Submit. (Read Current = ignore/no action)
Caution: After Submit changes are applied immediately to the BS. Therefore the
PC must now be re-configured to the new configuration (IP address and Subnet
mask) to re-establish communication.
1. Return to General Config and in the BS Action.
2. Select Reset BS from the dropdown list.
3. Click Submit to perform a reset of the BS.
8.1.4 BS Operational State
Note: Leave settings on BS Operational State as is. No configuration is required.