User Manual

Air4G-W24 Installation Guide
Page 57 Commercial in Confidence UGD-D00181 Rev G
8 Initial WEB Configuration
Configure an Air4G-W24 base station using the built in web based interface. This prepares the
equipment for connection to Netspan.
8.1 Initial configuration
To set initial configuration, perform the following:
Caution: The GPS antenna should be installed and attached before Air4G-W24
is powered on.
Caution: Wait two minutes before performing other actions.
1. Apply power to the Air4G-W24.
2. With the Air4G-W24 powered-up connect the PC to the Ethernet port.
3. Configure the PC with an IP address in the 192.168.0.xxx range (e.g. 192.168.0.xxx
subnet 255.255.255.0).
4. In a browser, open web page with address 192.168.0.1 (Air4G-W24 default IP address).
5. Enter the default username and password:
Username = macromaxe
Password = macromaxe
8.1.1 General Config
Figure 43 – General BS Configuration Initial