User Manual

Air4G-W24 Installation Guide
Page 51 Commercial in Confidence UGD-D00181 Rev G
Figure 34 - GPS cable assembly prior to mounting
3. Hand-tighten the RG58 cable TNC (90°) connector to the mating connector on the GPS
antenna.
Figure 35 - Attach GPS antenna to RG58 cable
4. Slide the flat washer up to the underside of the mounting bracket, then thread 1 nut onto
the GPS antenna threaded base and tightened.
5. The second nut is then secured and tightened against the first nut to create a clamp load
against the first nut, as shown below:
Figure 36 - GPS antenna assembled on bracket
6. Connect the RG58 cable attached to the GPS Lightning/Surge protector (required) to the
GPS connection on the bottom Air4G-W24.