User Manual

Air4G-W24 Installation Guide
Page 39 Commercial in Confidence UGD-D00181 Rev G
Note: Remove long (assembled) strap and replace with short strap (supplied).
1. Wrap the band to properly fit on the pole. Set the slot on the hook to insure a tight fit.
2. Align and position each of the 2 pole clamp brackets at the heights required to attach the
Air4G-W24 (with the threaded holes facing up). Adjust the upper bracket and tighten in
place. Adjust the lower bracket and hand-tighten.
Note: Remove assembled screws (2) and washers (4) for later use.
3. Lift the rear wall mount and place the screws through the head clearance holes and
position the unit so that the top mounting holes retain the unit.
Caution: These units weigh over 17 kg., take care when lifting.
4. Screw the bottom two the M8 screws and washers into the two standoff fittings at the
bottom of the Air4G-W24 enclosure.
5. Check and tighten all fixing screws.
Figure 17 – Pole Mounted Air4G-W24
To mount the Air4G-W24 in the pole mount configuration (for poles 60 > 120 mm), perform
the following steps:
1. Attach the two (2) pole brackets (shown above in Table 6) to the pole (with the threaded
holes facing up) at the heights required to attach the Air4G-W24.
2. Tighten upper pole bracket and hand tighten (loosely) the lower pole bracket for later
adjustment.
Caution: These units weigh 17 kg – 17.6 kg, take care when lifting.
3. Lift and align the Air4G-W24 unit and place the screws through the head clearance holes
and position the unit so that the top mounting holes retain the unit and loosely tighten all
screws.
4. Tighten all fixing screws.