User Manual

Air4G-W24 Installation Guide
Page 37 Commercial in Confidence UGD-D00181 Rev G
5 Install Air4G-W24
Install the Air4G-W24 base station by pole mount, wall mount, or single point. The Air4G-W24
can be deployed as a remote radio head (RRH) connected to a pair of single (usually vertically
polarized) or single dual independently mounted antennas via standard RF coaxial cables.
Antennas are positioned with up to 10 wavelengths horizontal separation to give optimal Downlink
and Uplink MIMO performance.
Caution: Proper local rigging and hoisting practices should be followed when
installing the Air4G-W24. The pre-assembled handles are not to be used for
hanging, attaching or hoisting the unit into place.
5.1 Pole mount configuration
The following image shows the pole mount assembly.
Figure 12 – Pole Mounted Air4G-W24 Assembly
To mount the Air4G-W24 in the pole mount configuration (for poles 170 > 230 mm), perform
the following steps:
Figure 13 - pole mounting bracket (2 required)
1. Wrap the band to properly fit on the pole. Set the slot on the hook to insure a tight fit.