User Manual

Air4G-W24 Installation Guide
Page 30 Commercial in Confidence UGD-D00181 Rev G
Air4G-W24 Base
Station parts
Consisting of
GPS antenna &
accessories
(each ordered
separately)
1x GPS Antenna. An active GPS antenna which, by using the
appropriate mounting bracket, can be used with Air4G-W24 for network
synchronization.
For mounting directly to the top of Air4G-W24, this GPS Antenna should
be used in conjunction with Air4G-W24 GPS Antenna mounting bracket
w/Handle pre-assembled on the Air4G-W24 and the 80cm GPS Cable
RG58 TNC-TNC.
When mounting remotely from the base station unit, this antenna should
be used in conjunction with the Remote GPS Antenna Mounting Bracket
(GPS-MNT-1) and the 16m GPS Cable RG58 TNC-TNC.
80cm or 16m Cable Assembly - 80cm (CBL-GPS-TNC-0.8-1) or 16m
(CBL-GPS-TNC-16-1) RG58 cable. 16m connects remote mounted
GPS Antenna (GPS-ANT-1) to the Air4G-W24 via TNC connectors. The
80cm, cable for mounting GPS directly to the top of Air4G-W24.
GPS Lightning/Surge
protector (ordered
separately)
1x Lightning/Surge protector (required)
AC/DC Power Supply
(PS)
Indoor power converter for 700 MHz
Indoor power converter for 2.xGHz
Outdoor power converter for 3.xGHz
Type-IC DC Power
Cable
Available either in - 10, 15 or 30 meter lengths. Additional lengths
available.
ODC Twin Fiber Cable
(Multimode) (optional)
(ordered separately)
Available either in - 10, 15, 30, 50, 75 or 100 meter lengths.
Note: Maximum up to 500 meters as this is a
multimode interface.
Multimode fiber pigtail
cable (not included)
(optional) (ordered
separately)
Multimode fiber pigtail cable – ODC - LC connector. Terminates the
outdoor fiber cable and provides an indoor LC connector. 2 meter
length.
Grounding Cable
(required) (not
included)
Circular earth braid, 120A current (16 mm²), jacketed or not with cable
size = AWG 4 – 6 with lug (terminal) on enclosure side with hole M6
The Air4G-W24 power supply (PS) can be installed with various cable lengths according to the
site requirements. The cable lengths are determined by the length of the run between the PS and
the Air4G-W24. Use the following table to determine the required power supply output to ensure
proper operation of the Air4G-W24.
Table 11 - Input Power for Air4G-W24
Air4G-W24 2x10
(2.3-2.7 GHZ)
&
Air4G-W24 0707
(698-746 MHz)
Air4G-W24 3x05
(3.3-3.38 GHZ)
Input Voltage to Air4G-W24 (1)
-38 VDC to -60 VDC
-38 VDC to -60 VDC
PS output Voltage – 30 meter cable
(2)
-42 VDC min
-41 VDC min