User Manual
Table Of Contents
- 1 About this Guide
- 2 System Overview
- 3 Installation Prerequisites
- 4 Physical Description
- 5 BSDU Description
- 6 GPSD Description
- 7 GPS Description
- 8 AC/DC Power Converter
- 9 Mounting the Base Station Radio (BSR)
- 10 Mounting the BSDU
- 11 Mounting the GPS
- 12 Mounting the AC/DC Power Converter
- 13 Cabling the BSR
- 14 Connecting the SDA-4S to the power supply
- 15 Connecting Power Cable for SDA-4SDC
- 16 Connecting BSDU to AC/DC Power converter
- 17 Lightning and Surge Protection
- 18 Connecting Third-Party External Antennas
- 19 Appendix
MicroMAX Hardware Installation User Guide
Page 87 Commercial in Confidence UWB-D00068 Rev J
Figure76‐Ringterminal
Figure77–CAT‐5eSFTPcablewithringterminal
Figure78‐CompleteassemblywithFerrite(optional)
17.3 FM Interference & ESD Protection Recommendations
When FM Interference is a factor:
¾ Ferrite suppressor (displayed in figure above) on the CAT-5e cable, near BSR
¾ Loop the CAT-5e cable on the BSR end
When ESD is an issue:
¾ Verify that the CAT-5e SFTP cable properly grounded at both ends
17.4 Connecting Lightning and Surge Protector
The optional third-party lightning and surge protector (Polyphaser) is implemented in the following
deployment scenarios:
¾ ODU-to-IDU cable length of 40 meters or more (mandatory to use surge protector)