User Manual
Table Of Contents
- 1 About this Guide
- 2 System Overview
- 3 Installation Prerequisites
- 4 Physical Description
- 5 BSDU Description
- 6 GPSD Description
- 7 GPS Description
- 8 AC/DC Power Converter
- 9 Mounting the Base Station Radio (BSR)
- 10 Mounting the BSDU
- 11 Mounting the GPS
- 12 Mounting the AC/DC Power Converter
- 13 Cabling the BSR
- 14 Connecting the SDA-4S to the power supply
- 15 Connecting Power Cable for SDA-4SDC
- 16 Connecting BSDU to AC/DC Power converter
- 17 Lightning and Surge Protection
- 18 Connecting Third-Party External Antennas
- 19 Appendix
MicroMAX Hardware Installation User Guide
Page 77 Commercial in Confidence UWB-D00068 Rev J
Figure65‐ConnecttoNegative
4. Connect the RED crimped wire from the 25-pin cable now to Port J1 on the back panel of the
AC/DC Convertor to the +VDC (Positive) output of the AC/DC Convertor on the back panel,
as shown below.
Figure66‐ConnecttoPositive
5. Check the back panel of the BSDU and AC/DC Convertor appears as below:
Figure67‐Backpanels
6. Connect the power cable terminated with the Anderson Powerpole connectors to the -48V
input on the front panel of the BSDU, as shown below.