User Manual
Table Of Contents
- 1 About this Guide
- 2 System Overview
- 3 Installation Prerequisites
- 4 Physical Description
- 5 BSDU Description
- 6 GPSD Description
- 7 GPS Description
- 8 AC/DC Power Converter
- 9 Mounting the Base Station Radio (BSR)
- 10 Mounting the BSDU
- 11 Mounting the GPS
- 12 Mounting the AC/DC Power Converter
- 13 Cabling the BSR
- 14 Connecting the SDA-4S to the power supply
- 15 Connecting Power Cable for SDA-4SDC
- 16 Connecting BSDU to AC/DC Power converter
- 17 Lightning and Surge Protection
- 18 Connecting Third-Party External Antennas
- 19 Appendix
MicroMAX Hardware Installation User Guide
Page 46 Commercial in Confidence UWB-D00068 Rev J
9 Mounting the Base Station Radio (BSR)
The MicroMAX BSR can be pole-mounted or wall-mounted (optional). Pole mounting allows the
BSR to be easily adjusted in the horizontal (azimuth) and vertical (elevation) planes for antenna
alignment.
For either mounting method, the MicroMAX provides mounting holes (displayed in the figure
below), molded into its back panel for attaching the mounting brackets.
Note: The BSR fully complies with IP Code - IPX6 for product enclosure
protection.
Warning: The BSR device is an outdoor radio unit, and therefore, must only
be mounted outside.
Warning: Warning: Mount the MicroMAX in an orientation such that its ports
(located on the bottom panel) faces downwards. This prevents rain water
from settling on the ports, and thereby, avoiding damage to the unit such as
corrosion and electrical short-circuiting.
Figure25‐BSR‐rearview
Note: The standard BSR kit provides pole-mounting brackets. If you want to
wall-mount the MicroMAX, contact your Airspan distributor for pricing and
ordering of wall-mounting brackets.