User Manual

MacroMAXe-4RX Installation Guide
Page 50 Commercial in Confidence UGD-D00181 Rev F2
Figure 30 - Secure fiber-optic cable, place tie
2. Pull or slide the Millie-Tie onto the target. Note that the Millie Tie stretches to cushion the
installation.
Figure 31 – Secure fiber-optic cable, pull tie
3. Release the tension when snug, then cut and remove any excess strip. Always cut through
the square sections, not the wider cells.
Figure 32 – Secure fiber-optic cable, snug tie
Note: Millie-Tie is efficient, and simply gets a little shorter after each use. The
remaining strip can be kept and reused.
Figure 33 – Secure fiber-optic cable, cut excess tie
6. Repeat these steps for each use.