User Manual

MacroMAXe-4RX Installation Guide
Page 39 Commercial in Confidence UGD-D00181 Rev F2
5.3.2 Install Quad Slant Antenna
Figure 16 – MacroMAXe Antenna Quad Slant Mast Mount Configuration
To mount the Quad slant antenna for the MacroMAXe in the mast mount configuration,
perform the following steps:
1. Attach the Antenna brackets to the top and bottom of the radome.
2. Attach to the top bracket of the radome.
3. Fasten the ends of the adjustable pipe mounts to the top and bottom brackets of the radome.
4. Lift the radome and place the screws through the adjustable pipe mounts and position the
radome so that the top mounting holes retain the unit.
5. Screw the bottom two screws and washers into the two standoff fittings at the bottom of the
radome assembly.
6. Tighten all fixing screws.
7. Attach, connect and secure antenna RF cable between the antenna and the appropriate
MacroMAXe Antenna RF connection on the top of the unit.
5.3.3 Antenna Mounting Clamps for Dual and Quad Slant Antennae
The following are some adjustable antenna mounting clamp options for both Dual and Quad Slant
antenna scenarios.