User Manual

MacroMAXe-4RX Installation Guide
Page 35 Commercial in Confidence UGD-D00181 Rev F2
Figure 11 – Pole Mounted MacroMAXe
To mount the MacroMAXe in the pole mount configuration (for poles 60 > 120 mm), perform
the following steps:
1. Attach the two (2) pole brackets (shown above in Table 6) to the pole (with the threaded holes
facing up) at the heights required to attach the MacroMAXe.
2. Tighten upper pole bracket and hand tighten (loosely) the lower pole bracket for later
adjustment.
Caution: These units weigh 17 kg – 17.6 kg, take care when lifting.
3. Lift and align the MacroMAXe unit and place the screws through the head clearance holes
and position the unit so that the top mounting holes retain the unit and loosely tighten all
screws.
4. Tighten all fixing screws.
5.2 Wall mount configuration
The following image shows the wall mount assembly.
Figure 12 – Wall Mounted MacroMAXe