User Manual

MacroMAXe-4RX Installation Guide
Page 27 Commercial in Confidence UGD-D00181 Rev F2
MacroMAXe Base
Station parts
Consisting of
Note: The Sunshield brackets are only applicable for antennas that utilize
Mechanical Electric Tilt (MET). i.e. – Argus-SSPX310F.
Warning: A Sunshield is mandatory for temperatures of above 45°.
1 x MacroMAXe
installation mount kit
(ordered separately)
M8 x 20 Hex Cap screws – 8
M8 Hex nuts - 4
M8 plain washers – 8
M8 spring washers - 8
Pole Mount Bracket
Assembly:
Dia. 120-230 mm – top &
bottom – plus fixing
accessories.
(ordered separately)
Accessories included
Pole Mount Bracket
Assembly:
Dia. 60-120 mm – top &
bottom – plus fixing
accessories.
(ordered separately)
Accessories included
1 x earth kit
1 x M5 screws
1 x M5 washers
1 x M5 spring washers
Alternative: SEMS screw (includes 2 washers)
1 x GPS antenna kit
(ordered separately)
1x GPS Antenna. An active GPS antenna which, by using the
appropriate mounting bracket, can be used with MacroMAXe for
network synchronization.
For mounting directly to the top of MacroMAXe, this GPS Antenna
should be used in conjunction with MacroMAXe GPS Antenna mounting
bracket w/Handle.
When mounting remotely from the base station units, this antenna
should be used in conjunction with the Remote GPS Antenna Mounting
Bracket & 5m or 16m GPS Cable RG58 TNC-TNC.
80cm or 16m Cable Assembly. 80cm or 16m RG58 cable. 16m
connects remote mounted GPS Antenna (GPS-ANT-1) to the
MacroMAXe via TNC connectors. 80cm, cable for mounting GPS
directly to the top of MacroMAXe.
GPS Lightning/Surge
protector (ordered
separately)
1x Lightning/Surge protector
AC/DC Power Supply (PS)
Indoor power converter for 700 MHz
Indoor power converter for 2.xGHz