User Manual
Table Of Contents
- Copyright
- Table of Contents
- Summary of Figures
- Summary of Tables
- Warnings and Cautions
- DECLARATION OF CONFORMITY
- FCC Notice
- Maximum Output TX Power
- 1 About this Guide
- 2 Introduction
- 3 Getting Started
- 4 Verify Prerequisites
- 5 Install Air4G
- 5.1 Pole mount configuration
- 5.2 Wall mount configuration
- 5.3 Surge Protector Mounting
- 5.4 Air4G Connections
- 5.5 Install Air4G Antennas
- 5.6 Optional Mounting Antenna on Air4G
- 5.7 Cavity Filter Installation
- 5.8 External Duplexer Installation
- 5.9 Antenna Connection
- 5.10 GPS Antenna Assembly
- 5.11 LED Display
- 5.12 Install Junction Box (Optional)
- 6 Connect and Manage Cables
- 7 Set Power System
- 8 Initial WEB Configuration
- 9 Appendix A
- 10 Appendix C – Glossary of Terms
- 11 Appendix D – Installation Checklist
- 12 Appendix E
Air4G Installation Guide
Page 72 Commercial in Confidence UGD-D00229 Rev B
11 Appendix D – Installation Checklist
The Checklist below gives the high-level steps in the Workflow for this procedure. Detach or print
this page to use as a job-aid for completing the actions this procedure requires.
Table 27 - Checklist for Procedure
Procedure
Actions
Outcome
1. Verify Prerequisites
Verify safety
requirements
Verify installation
requirements
All requirements are in
place for a successful
commissioning of Air4G.
2. Install Air4G
Pole mount configuration
Wall mount configuration
Install Air4G antennas
3. Connect and manage
cables
Assemble Ethernet
connector or
Disassemble Ethernet
connector, then
Assemble LTW Ethernet
connector
4. Set power system
Power input
Power output