User Manual
Table Of Contents
- Copyright
- Table of Contents
- Summary of Figures
- Summary of Tables
- Warnings and Cautions
- DECLARATION OF CONFORMITY
- FCC Notice
- Maximum Output TX Power
- 1 About this Guide
- 2 Introduction
- 3 Getting Started
- 4 Verify Prerequisites
- 5 Install Air4G
- 5.1 Pole mount configuration
- 5.2 Wall mount configuration
- 5.3 Surge Protector Mounting
- 5.4 Air4G Connections
- 5.5 Install Air4G Antennas
- 5.6 Optional Mounting Antenna on Air4G
- 5.7 Cavity Filter Installation
- 5.8 External Duplexer Installation
- 5.9 Antenna Connection
- 5.10 GPS Antenna Assembly
- 5.11 LED Display
- 5.12 Install Junction Box (Optional)
- 6 Connect and Manage Cables
- 7 Set Power System
- 8 Initial WEB Configuration
- 9 Appendix A
- 10 Appendix C – Glossary of Terms
- 11 Appendix D – Installation Checklist
- 12 Appendix E
Air4G Installation Guide
Page 68 Commercial in Confidence UGD-D00229 Rev B
Figure 65 – Secure fiber-optic cable, use excess tie
Figure 66 – Secure fiber-optic cable, re-use excess tie
9.3 Connecting the Fiber-optic Cable
To secure fiber-optic cable to the Air4G, perform the following steps:
1.
Remove the dust cover from end of a panel connector:
Figure 67 - fiber-optic connector with dust cover
Figure 68 – dust cover removed
2. Remove the protective cover from the fiber-optical cable.
3. Align the fiber-optical cable connector and line up the groove on the cable connector with
the pin on the panel connector.
4. Screw the connecter cover nut until hand-tight.