User Manual
Table Of Contents
- Copyright
- Table of Contents
- Summary of Figures
- Summary of Tables
- Warnings and Cautions
- DECLARATION OF CONFORMITY
- FCC Notice
- Maximum Output TX Power
- 1 About this Guide
- 2 Introduction
- 3 Getting Started
- 4 Verify Prerequisites
- 5 Install Air4G
- 5.1 Pole mount configuration
- 5.2 Wall mount configuration
- 5.3 Surge Protector Mounting
- 5.4 Air4G Connections
- 5.5 Install Air4G Antennas
- 5.6 Optional Mounting Antenna on Air4G
- 5.7 Cavity Filter Installation
- 5.8 External Duplexer Installation
- 5.9 Antenna Connection
- 5.10 GPS Antenna Assembly
- 5.11 LED Display
- 5.12 Install Junction Box (Optional)
- 6 Connect and Manage Cables
- 7 Set Power System
- 8 Initial WEB Configuration
- 9 Appendix A
- 10 Appendix C – Glossary of Terms
- 11 Appendix D – Installation Checklist
- 12 Appendix E
Air4G Installation Guide
Page 64 Commercial in Confidence UGD-D00229 Rev B
Figure 59 - Management IP Configuration
2. Define the IP address.
3. Define the Subnet Mask.
4. Define the Default GW MAC Address.
Caution: Define Default GW only if required for Network Security. Consult with
Provider.
1. Set the Management VLAN set to Untagged. Set to Tagged when with VLAN Tag ID.
Consult with Provider.
2. Define the VLAN Tag ID – only when Management VLAN is set to Tagged. Consult with
Provider.
3. Click Submit. (Read Current = ignore/no action)
Caution: After Submit changes are applied immediately to the BS. Therefore the
PC must now be re-configured to the new configuration (IP address and Subnet
mask) to re-establish communication.
1. Return to General Config and in the BS Action.
2. Select Reset BS from the dropdown list.
3. Click Submit to perform a reset of the BS.
8.1.4 BS Operational State
Note: Leave settings on BS Operational State as is. No configuration is required.