User Manual
Table Of Contents
- Copyright
- Table of Contents
- Summary of Figures
- Summary of Tables
- Warnings and Cautions
- DECLARATION OF CONFORMITY
- FCC Notice
- Maximum Output TX Power
- 1 About this Guide
- 2 Introduction
- 3 Getting Started
- 4 Verify Prerequisites
- 5 Install Air4G
- 5.1 Pole mount configuration
- 5.2 Wall mount configuration
- 5.3 Surge Protector Mounting
- 5.4 Air4G Connections
- 5.5 Install Air4G Antennas
- 5.6 Optional Mounting Antenna on Air4G
- 5.7 Cavity Filter Installation
- 5.8 External Duplexer Installation
- 5.9 Antenna Connection
- 5.10 GPS Antenna Assembly
- 5.11 LED Display
- 5.12 Install Junction Box (Optional)
- 6 Connect and Manage Cables
- 7 Set Power System
- 8 Initial WEB Configuration
- 9 Appendix A
- 10 Appendix C – Glossary of Terms
- 11 Appendix D – Installation Checklist
- 12 Appendix E
Air4G Installation Guide
Page 53 Commercial in Confidence UGD-D00229 Rev B
the quad port antenna. The Air4G Rx ports need to be connected to the remaining connectors on
the antenna side. Two (2) examples are displayed below.
Table 24 - Antenna connection
Air4G port
Port Label on Air4G
Port on the quad port antenna
Tx/Rx
ANT 1
+45 degree of “first antenna”
Tx/Rx
ANT 2
-45 degree of “second antenna”
Tx/Rx or Rx only
ANT 3
-45 degree of “first antenna”
Tx/Rx or Rx only
ANT 4
+45 degree of “second antenna”
Figure 42 - Quad port antenna connection – 1
Figure 43 - Quad port antenna connection – 2
5.10 GPS Antenna Assembly
The GPS antenna should be installed far from:
High-voltage power cables.
Strong radiation area of any TV transmission stations.