User Manual
Table Of Contents
- Copyright
- Table of Contents
- Summary of Figures
- Summary of Tables
- Warnings and Cautions
- DECLARATION OF CONFORMITY
- FCC Notice
- Maximum Output TX Power
- 1 About this Guide
- 2 Introduction
- 3 Getting Started
- 4 Verify Prerequisites
- 5 Install Air4G
- 5.1 Pole mount configuration
- 5.2 Wall mount configuration
- 5.3 Surge Protector Mounting
- 5.4 Air4G Connections
- 5.5 Install Air4G Antennas
- 5.6 Optional Mounting Antenna on Air4G
- 5.7 Cavity Filter Installation
- 5.8 External Duplexer Installation
- 5.9 Antenna Connection
- 5.10 GPS Antenna Assembly
- 5.11 LED Display
- 5.12 Install Junction Box (Optional)
- 6 Connect and Manage Cables
- 7 Set Power System
- 8 Initial WEB Configuration
- 9 Appendix A
- 10 Appendix C – Glossary of Terms
- 11 Appendix D – Installation Checklist
- 12 Appendix E
Air4G Installation Guide
Page 50 Commercial in Confidence UGD-D00229 Rev B
5.7 Cavity Filter Installation
The following demonstrates the correct installation of a Cavity filter for the Air4G in either the wall
or mast mount configuration.
Note: The Cavity filters are required for the 2.3 GHz variant only.
Figure 37 - Cavity filter(s) installation
5.8 External Duplexer Installation
The following demonstrates the installation of the external Duplexer for the Air4G in the pole
mount configuration.
Note: The external Duplexer are required for some FDD variant only.
To mount the External Duplexer in the pole mount configuration (for poles 50 > 215 mm),
perform the following steps:
Note: Utilize the supplied bands according to pole diameter.