User Manual
Table Of Contents
- Copyright
- Table of Contents
- Summary of Figures
- Summary of Tables
- Warnings and Cautions
- DECLARATION OF CONFORMITY
- FCC Notice
- Maximum Output TX Power
- 1 About this Guide
- 2 Introduction
- 3 Getting Started
- 4 Verify Prerequisites
- 5 Install Air4G
- 5.1 Pole mount configuration
- 5.2 Wall mount configuration
- 5.3 Surge Protector Mounting
- 5.4 Air4G Connections
- 5.5 Install Air4G Antennas
- 5.6 Optional Mounting Antenna on Air4G
- 5.7 Cavity Filter Installation
- 5.8 External Duplexer Installation
- 5.9 Antenna Connection
- 5.10 GPS Antenna Assembly
- 5.11 LED Display
- 5.12 Install Junction Box (Optional)
- 6 Connect and Manage Cables
- 7 Set Power System
- 8 Initial WEB Configuration
- 9 Appendix A
- 10 Appendix C – Glossary of Terms
- 11 Appendix D – Installation Checklist
- 12 Appendix E
Air4G Installation Guide
Page 40 Commercial in Confidence UGD-D00229 Rev B
4. Screw the bottom two screws and washers into the two standoff fittings at the bottom of
the Air4G enclosure.
5. Tighten all fixing screws.
5.2.1 Mounting Examples
The following displays a typical wall mount.
Figure 21 - Wall mount
Note: The GPS bracket (pre-assembled) is on the (back) side closest to the wall
so as not to interfere with the sunshield assembly.
The following displays a possible assembly alternative in the event of interference to the GPS by
equipment already in place.
Figure 22 - GPS alternative assembly
5.3 Surge Protector Mounting
The Surge protector connects to the base station GPS antenna connector cable on one side and
the GPS antenna cable on the other side.