User Manual
Table Of Contents
- Copyright
- Table of Contents
- Summary of Figures
- Summary of Tables
- Warnings and Cautions
- DECLARATION OF CONFORMITY
- FCC Notice
- Maximum Output TX Power
- 1 About this Guide
- 2 Introduction
- 3 Getting Started
- 4 Verify Prerequisites
- 5 Install Air4G
- 5.1 Pole mount configuration
- 5.2 Wall mount configuration
- 5.3 Surge Protector Mounting
- 5.4 Air4G Connections
- 5.5 Install Air4G Antennas
- 5.6 Optional Mounting Antenna on Air4G
- 5.7 Cavity Filter Installation
- 5.8 External Duplexer Installation
- 5.9 Antenna Connection
- 5.10 GPS Antenna Assembly
- 5.11 LED Display
- 5.12 Install Junction Box (Optional)
- 6 Connect and Manage Cables
- 7 Set Power System
- 8 Initial WEB Configuration
- 9 Appendix A
- 10 Appendix C – Glossary of Terms
- 11 Appendix D – Installation Checklist
- 12 Appendix E
Air4G Installation Guide
Page 36 Commercial in Confidence UGD-D00229 Rev B
5 Install Air4G
Install the Air4G base station by pole mount, wall mount, or single point. The Air4G can be
connected to various types of antennas via standard RF coaxial cables. Antennas are positioned
with up to 10 wavelengths horizontal separation to give optimal Downlink and Uplink MIMO
performance.
Caution: Proper local rigging and hoisting practices should be followed when
installing the Air4G. The pre-assembled handles are not to be used for hanging,
attaching or hoisting the unit into place.
5.1 Pole mount configuration
The following image shows the pole mount assembly.
Figure 12 – Pole Mounted Air4G Assembly
To mount the Air4G in the pole mount configuration (for poles 120 > 230 mm), perform the
following steps:
Note: Utilize appropriate straps either long (assembled) straps and or short straps
(supplied) according to pole diameter.
Figure 13 - pole mounting bracket (2 required)
1. Wrap the band to properly fit on the pole. Set the slot on the hook to insure a tight fit.