User Manual
Table Of Contents
- Copyright
- Table of Contents
- Summary of Figures
- Summary of Tables
- Warnings and Cautions
- DECLARATION OF CONFORMITY
- FCC Notice
- Maximum Output TX Power
- 1 About this Guide
- 2 Introduction
- 3 Getting Started
- 4 Verify Prerequisites
- 5 Install Air4G
- 5.1 Pole mount configuration
- 5.2 Wall mount configuration
- 5.3 Surge Protector Mounting
- 5.4 Air4G Connections
- 5.5 Install Air4G Antennas
- 5.6 Optional Mounting Antenna on Air4G
- 5.7 Cavity Filter Installation
- 5.8 External Duplexer Installation
- 5.9 Antenna Connection
- 5.10 GPS Antenna Assembly
- 5.11 LED Display
- 5.12 Install Junction Box (Optional)
- 6 Connect and Manage Cables
- 7 Set Power System
- 8 Initial WEB Configuration
- 9 Appendix A
- 10 Appendix C – Glossary of Terms
- 11 Appendix D – Installation Checklist
- 12 Appendix E
Air4G Installation Guide
Page 32 Commercial in Confidence UGD-D00229 Rev B
Optional Junction Box
Consisting of
2 x mounting bracket(s) for pole and wall
mounting
Bracket (x2)
2 x pole bands (stainless steel), as required,
supplied.
52 – 76 mm (3”)
2 x pole bands (stainless steel), as required,
supplied.
78 – 102 mm (4”)
Mounting screws – for mounting brackets to
junction box.
EJOT WN1412 – K50 x 12 – 4 supplied.
Wall mounting fasteners
Hole size = 7 mm
Sufficient cable wires ties, as required
(not supplied - customer responsibility)
Table 18 - External Duplexer (for some FDD variants only)
Parts Images
Note: the exact Duplexer might
appear different than shown.
1 External Duplexer
(for some FDD variants only) +
RF cables.
1 2 x pole bands (stainless steel)
(for 50-215 mm pole)
4.2.3 Verify Components
Air4G is shown below from the Ethernet termination and RF port end views respectively.