User Manual

Air4G Installation Guide
Page 27 Commercial in Confidence UGD-D00229 Rev B
Air4G Base
Station parts
Consisting of
Filter (Cavity
filter) Kit (for
2.3 GHz variant
only) (U.S.A. –
WCS market
only)
2 x Cavity Filters – 141-00-148
4 x antenna cables – 689-000-47
4 x stainless steel pole bands for pole mounting
External
Duplexer Kit
(for some FDD
variants only) –
Supplied with
Air4G
1 x External Duplexer (with pre-assembled mounting bracket)
2 x 50-215 mm stainless steel pole bands for pole mounting
4 x RF jumper cables (1.5 m each) for connecting 2 x (Tx + Rx) between the
Air4G antenna ports and the Duplexer
RF cable
(ordered
separately)
2 x antenna cables for connecting the antennas to the Air4G / External
Duplexer.
The following table displays the parts contained in the included GPS Kit and when the parts are
required per configuration. See GPS Antenna Assembly
= required when applicable for this configuration
X = not required in this configuration
Table 11 - GPS Kit Contents
Part
Description
Air4G
Air4Gp
Air4Gs
Image
Ext.
Int.
GPS Antenna
1 x GPS Antenna. An active GPS
antenna which, with the appropriate
mounting bracket is used with the
BS for network synchronization.
   
80cm GPS
Cable
- RG58
TNC
-TNC
See
Optional
Cables
For mounting the GPS directly to
the top of the BS. S
hould be used in
conjunction with the BS GPS
antenna mounting bracket pre-
assembled on the BS. P/N CBL-
GPS-TNC-0.8-1
  


Remote GPS
Antenna
Mounting
Bracket
Used in conjunction with the long
GPS Cable - when mounting GPS
remotely.
(see optional cables below)
  

Lightning/Surge
protector
Surge Protector designed to protect
from lightning strikes.
An additional mounting bracket
included in the packaging is not
required for use.
  


Warning: Surge protection requires proper grounding to provide
proper protection against surge damage due to lightning or other surge
events.