User Manual
Table Of Contents
- Copyright
- Table of Contents
- Summary of Figures
- Summary of Tables
- Warnings and Cautions
- DECLARATION OF CONFORMITY
- FCC Notice
- Maximum Output TX Power
- 1 About this Guide
- 2 Introduction
- 3 Getting Started
- 4 Verify Prerequisites
- 5 Install Air4G
- 5.1 Pole mount configuration
- 5.2 Wall mount configuration
- 5.3 Surge Protector Mounting
- 5.4 Air4G Connections
- 5.5 Install Air4G Antennas
- 5.6 Optional Mounting Antenna on Air4G
- 5.7 Cavity Filter Installation
- 5.8 External Duplexer Installation
- 5.9 Antenna Connection
- 5.10 GPS Antenna Assembly
- 5.11 LED Display
- 5.12 Install Junction Box (Optional)
- 6 Connect and Manage Cables
- 7 Set Power System
- 8 Initial WEB Configuration
- 9 Appendix A
- 10 Appendix C – Glossary of Terms
- 11 Appendix D – Installation Checklist
- 12 Appendix E
Air4G Installation Guide
Page 23 Commercial in Confidence UGD-D00229 Rev B
3 Getting Started
3.1 Workflow of Installation
The Workflow to install the Air4G is shown in the following diagram:
Figure 4 – Workflow of Installation
Caution: Antennas 1 & 2 Tx/Rx must be connected and attached before Air4G is
powered on.
3.2 Air4G Installation Checklist
Plan the installation of the Air4G by using the Installation Checklist, which you can find as a
removable job aid in Appendix A
for this guide.