User Manual
Table Of Contents
- Copyright
- Table of Contents
- Summary of Figures
- Summary of Tables
- Warnings and Cautions
- DECLARATION OF CONFORMITY
- FCC Notice
- Maximum Output TX Power
- 1 About this Guide
- 2 Introduction
- 3 Getting Started
- 4 Verify Prerequisites
- 5 Install Air4G
- 5.1 Pole mount configuration
- 5.2 Wall mount configuration
- 5.3 Surge Protector Mounting
- 5.4 Air4G Connections
- 5.5 Install Air4G Antennas
- 5.6 Optional Mounting Antenna on Air4G
- 5.7 Cavity Filter Installation
- 5.8 External Duplexer Installation
- 5.9 Antenna Connection
- 5.10 GPS Antenna Assembly
- 5.11 LED Display
- 5.12 Install Junction Box (Optional)
- 6 Connect and Manage Cables
- 7 Set Power System
- 8 Initial WEB Configuration
- 9 Appendix A
- 10 Appendix C – Glossary of Terms
- 11 Appendix D – Installation Checklist
- 12 Appendix E
Air4G Installation Guide
Page 22 Commercial in Confidence UGD-D00229 Rev B
Figure 3 - Air4G – each sector connected separately
Note: Air4G can also be connected via a LAN Switch for greater Failsafe
protection.
Note: When the Fiber-Optic cable connection is employed the Ethernet cable
connection (Eth 1) is disabled.
Note: Auto-negotiation must always be enabled on the core network side.
Note: The Ethernet connection (Eth 2) can be enabled / disabled via the Air4G
WEB interface to prevent unauthorized use. Check to enable, uncheck to disable.
See
General Config.
Note: Illustrations above display the GPS connected directly to the top of the
units, there is also a remote GPS antenna option.