User's Manual

AirHarmony-4000 (Integrated Duplexers) Installation Guide
UGD-D01080 Airspan Commercial and Internal Use 38
Figure 32: Attaching wires
6. Insert into connector, the by alignment pin determines the correct orientation.
7. Tighten the tail nut on to the body forcing the seal to compress around the power cable.
Caution: Do not over tighten the connector or the tail nut. The nut should be tightened
to a torque of no more than 3.3 Nm (2.43 lb-ft) max.
Note: When securing the cable verify there is no tension on the connector so that it is
easy to disconnect and re-connect for future maintenance actions.
Caution: The internal plastic parts of the mating connector are keyed. Take care to align
these by visual inspection or by gently rotating the connector body until the key way
sections align and the pins engaged fully before tightening.
Figure 33: Power cable attached to AirHarmony-4000